Asphalt Driveway Replacement Cost in Texas (2026)

Asphalt Driveway Replacement in Texas runs $3.40–$7.76 per sq ft, with most projects landing near $4.85. Texas prices run close to the national median of $5.00 — within ±10%.

Texas 2026 pricing

Tier	Price per sq ft	What you get
Budget	$3.40	Entry-tier materials, contractor lower hourly rate
Typical	$4.85	Mid-tier materials, established local contractor
Premium	$7.76	Premium materials, top-rated installer, custom work

Source: National median $5.00 × BLS Regional Price Parity (2022) applied to Texas. Last updated 2026-05-25.

Why Texas pricing looks like this

Southern states like Texas benefit from lower labor costs but climate considerations (humidity, hurricane exposure, intense sun) affect material choices and pricing.

Specific factors that move Texas pricing relative to the national baseline:

Lower base labor rates — competitive contractor market keeps margins thinner
Hurricane / coastal humidity drives material upgrades (impact-rated, treated lumber)
Pest considerations (termite, carpenter ant) affect wood / siding specs
Year-round outdoor work season — fewer weather delays vs northern states

Pricing by major metro in Texas

Within Texas, metro-level pricing varies by labor market and cost of living. Multipliers below are applied to the state typical of $4.85.

Metro	Typical price	Range	Notes
Houston	$4.95	$3.47–$7.92	Close to state average
Dallas	$5.04	$3.54–$8.07	Close to state average
Austin	$5.24	$3.67–$8.38	+8% vs state avg (higher labor + CoL)
San Antonio	$4.75	$3.33–$7.60	Close to state average
Fort Worth	$4.90	$3.43–$7.84	Close to state average

Metro multipliers from BLS metro-level Regional Price Parity. Always verify with 2–3 local quotes — actual contractor pricing varies ±15% within a metro depending on specific neighborhood, season, and contractor availability.

Estimate your specific asphalt driveway replacement cost in Texas

Asphalt Driveway Replacement Cost Calculator

Enter your project size and specifics — we'll estimate the total range a local contractor is likely to quote.

Driveway Square Footage (per sq ft) Single-car drive ≈ 500–700 sq ft. Double = 1,000–1,400. Long single = 800–1,000.

Asphalt Thickness

Tear-Out of Existing Surface

Base Preparation

Edge Treatment

Your State

Estimated total project cost

—

Calculator defaults to National average. Switch the "Your State" dropdown to Texas to apply local pricing.

Frequently asked questions about Asphalt Driveway Replacement in Texas

How long does an asphalt driveway last?

A properly installed and maintained asphalt driveway lasts 15–20 years in temperate climates, 12–15 years in regions with hard winters or hot summers. Seal coating every 2–3 years extends life by 30–40%. Skip seal coating and you're looking at premature cracking within 8 years.

Resurface (overlay) or full replacement — when?

Overlay (2" of new asphalt on top of old) works if cracks are surface-level and the base is solid: $1.50–$3.00/sq ft, saves 50–60% vs full replacement. Full replacement is required if you see alligator cracking, deep potholes, edge crumbling, or pooling water — those signal base failure that no overlay will fix.

How thick should an asphalt driveway be?

Residential standard is 2" of asphalt over a 4–6" compacted gravel base. Heavy vehicles (RV, boat trailer, work trucks) need 3–4" of asphalt and 6–8" of base. Going thicker than spec wastes money — the base depth matters more than asphalt depth for longevity.

When should I seal coat after install?

Wait 6–12 months for the asphalt to fully cure before the first seal coat. After that, reseal every 2–3 years in temperate climates, every 1–2 years in regions with freeze-thaw cycles. A seal coat job runs $0.15–$0.35/sq ft DIY or $0.40–$0.80/sq ft hired.

Asphalt vs concrete — which is better?

Concrete lasts longer (30+ years vs 15–20) but costs $4–$12/sq ft installed — roughly double asphalt. Concrete cracks are harder to repair invisibly; asphalt cracks fill cleanly. In freeze-thaw climates, asphalt flexes better. In hot southern climates, asphalt softens. Choose by climate first, budget second.

Compare nearby states

National guide →
Full guide with all 50 states and methodology
District of Columbia pricing →
$4.24–$9.68 per sq ft
Delaware pricing →
$3.47–$7.92 per sq ft
Alabama pricing →
$3.01–$6.88 per sq ft

About this data. National baseline of $5 derives from aggregated 2026 quote data across major lead-gen platforms. State-level figures apply Bureau of Labor Statistics Regional Price Parity (2022, all-items) to the national baseline. We refresh quarterly and welcome corrections — email [email protected] if a local quote you received falls materially outside our state range. See full methodology.