Concrete Slab Cost in New Hampshire (2026)

Concrete Slab Cost in New Hampshire runs $4.03–$12.09 per sq ft, with most projects landing near $7.07. New Hampshire prices run close to the national median of $7.00 — within ±10%.

New Hampshire 2026 pricing

Tier	Price per sq ft	What you get
Budget	$4.03	Entry-tier materials, contractor lower hourly rate
Typical	$7.07	Mid-tier materials, established local contractor
Premium	$12.09	Premium materials, top-rated installer, custom work

Source: National median $7.00 × BLS Regional Price Parity (2022) applied to New Hampshire. Last updated 2026-05-25.

Why New Hampshire pricing looks like this

Northeastern states like New Hampshire carry higher labor and permit costs, with cold-weather climate adding 8–15% to seasonal pricing.

Specific factors that move New Hampshire pricing relative to the national baseline:

High permit costs — some municipalities charge $200–$800 above national norms
Older housing stock requires more retrofit / code-compliance work
Snow-load specs drive heavier structural materials (roofing, decks)
Tighter labor market — fewer skilled trades per capita than other regions

Pricing by major metro in New Hampshire

Within New Hampshire, metro-level pricing varies by labor market and cost of living. Multipliers below are applied to the state typical of $7.07.

Metro	Typical price	Range	Notes
Manchester	$7.21	$4.11–$12.33	Close to state average
Nashua	$7.42	$4.23–$12.69	Close to state average
Concord	$6.93	$3.95–$11.85	Close to state average
Portsmouth	$7.78	$4.43–$13.30	+10% vs state avg (higher labor + CoL)

Metro multipliers from BLS metro-level Regional Price Parity. Always verify with 2–3 local quotes — actual contractor pricing varies ±15% within a metro depending on specific neighborhood, season, and contractor availability.

Estimate your specific concrete slab cost cost in New Hampshire

Concrete Slab Cost Cost Calculator

Enter your project size and specifics — we'll estimate the total range a local contractor is likely to quote.

Slab Square Footage (per sq ft) Patio 10×12 = 120. Garage 2-car 20×20 = 400. Driveway 12×50 = 600. Garage 3-car 24×30 = 720.

Slab Thickness

Reinforcement

Surface Finish

Base Preparation

Your State

Estimated total project cost

—

Calculator defaults to National average. Switch the "Your State" dropdown to New Hampshire to apply local pricing.

Frequently asked questions about Concrete Slab Cost in New Hampshire

Asphalt vs concrete — which is better for a driveway?

Concrete lasts 30+ years vs asphalt's 15–20, and stays cleaner-looking long-term. But concrete costs roughly 2× asphalt installed ($7–$12/sq ft vs $3.50–$8/sq ft). Concrete cracks are harder to repair invisibly; asphalt cracks fill cleanly. In freeze-thaw climates, asphalt flexes better. Hot southern climates favor concrete — asphalt softens above 90°F.

How thick should a concrete slab be?

For light residential use (patios, walkways): 4" is standard with wire mesh. Garage floors and driveways for cars: 4–6" with mesh or light rebar. Heavy vehicles (RV, boat trailer, work trucks): 6" with rebar. Commercial-grade or industrial floors: 8"+ with engineered rebar grid. Going thicker than spec wastes money — proper base prep matters more than slab depth.

Do I need rebar or wire mesh in my slab?

Wire mesh is standard for residential slabs under 6" thick — adds $0.50–$1.00/sq ft, prevents minor cracking. Rebar (3/8" or 1/2" grid on 16" centers) is required for slabs 6"+ or any structural pour — adds $0.80–$1.50/sq ft. For small patios under 100 sq ft, fiber-reinforced concrete can replace mesh and is sometimes cheaper.

How long until I can use my new concrete slab?

Walk on it after 24–48 hours. Drive a car on it after 7 days. Park heavy vehicles or place heavy objects after 28 days — that's when concrete reaches design strength. The slab continues curing for months but the 28-day mark is when it's safe for full load. In hot weather, water the surface daily for the first week to prevent shrinkage cracks.

What does stamped or decorative concrete cost?

Plain broom-finished slab is the baseline. Exposed aggregate (pebble surface) adds $1.50–$3.00/sq ft. Stamped patterns (mimics brick, stone, slate) add $4–$8/sq ft. Integral coloring adds $1.50–$3.50/sq ft. Polished concrete (indoor floors) runs $3–$8/sq ft on top of the base slab cost. Stamped + colored together is the typical "premium patio" upgrade — total runs $12–$20/sq ft installed.

Compare nearby states

National guide →
Full guide with all 50 states and methodology
Massachusetts pricing →
$4.39–$13.17 per sq ft
New Jersey pricing →
$4.18–$12.57 per sq ft
Connecticut pricing →
$4.15–$12.45 per sq ft

About this data. National baseline of $7 derives from aggregated 2026 quote data across major lead-gen platforms. State-level figures apply Bureau of Labor Statistics Regional Price Parity (2022, all-items) to the national baseline. We refresh quarterly and welcome corrections — email [email protected] if a local quote you received falls materially outside our state range. See full methodology.